Small knowledge of crack-resistant mortar

Anti-crack mortar, a mortar make of a polymer emulsion and an admixture, which is make of a crack resistant, cement and sand, which is stir at a certain ratio and which can satisfy a certain deformation and maintain no cracking.

This is a new type of anti-cracking material, which solves a major problem that has been plaguing the construction industry – the problem of cracking in the light body insulation layer. It is a high-quality environmentally friendly material with high tensile strength and easy construction and anti-freezing.

The application of cellulose ether in it:

1. Water retention of hydroxypropyl methyl cellulose ether:
Enhanced water retention. Improve the phenomenon that cement, gypsum building materials are too fast and tidy and hydration is insufficient to cause poor hardening and cracking;

2, the workability of hydroxypropyl methyl cellulose ether:
Increased the plasticity of the mortar, improved the industrial application of the diffuse coating, and improved work efficiency;

3. Adhesion of hydroxypropyl methyl cellulose ether:
Because the mortar is plastically advance, it can bond the substrate and the adherend very well;

4. The slip resistance of hydroxypropyl methyl cellulose ether:
Because of its thickening effect, it can avoid the appearance of mortar and the phenomenon of slippage of the bonded material during construction.

Anti-cracking mortar application range:

Mainly used for exterior wall insulation or internal insulation, polystyrene board, extruded board and other outer cover.

Crack-resistant mortar construction method:

1. Remove dust, oil and debris from the wall and make the surface clean.

2. Preparation: mortar powder: water = 1:0.3, stir evenly with mortar mixer or portable mixer.

3. Do a point-like stick or thin stick method on the wall, and press it to achieve flatness.

4. Application rate: 3-5 kg/m2.

Crack-resistant mortar construction process:

<1> Grassroots treatment:
The surface of the bonded insulation board should be as flat as possible, clean and sturdy. if necessary, sanded with coarse sandpaper. The insulation board should be pressed tightly.The possible seams to be used for the insulation surface need to be leveled with rubber powder polystyrene granule insulation mortar.

<2> Preparation of materials:
Stir directly with water for 5 minutes, mix well and use.

<3> Construction of materials:
Use a stainless steel plastering knife to smear the crack-resistant mortar onto the heat-insulating board, press the glass fiber mesh into the warm plaster mortar and level it. the mesh joints should overlap, and the overlap width of 10 cm glass fiber cloth must be completely buried. The thickness of the fiber reinforced surface layer is about 2-5 cm.

Precautions:

1. On-site construction of crack-resistant mortar does not require the addition of any admixture, and the water-solid ratio and plastering time are strictly control.

2. The base layer with strong water absorption or excessively dry surface should be firstly coat with a sealing agent or spray with a small amount of water to wet it before construction.

3. Pay attention to moisture, rain and sun exposure during transportation.

4. During the storage process, the crack-resistant mortar should be stored in a dry and ventilate place to avoid moisture.

5. When the anti-cracking mortar is used, it can not be adjust too much at one time, depending on the amount of construction. If it is not used, it will agglomerate and cannot be used continuously.

6, construction and storage temperature requirements above 5 °C.

7. After each construction, clean the construction tools and mixing equipment in time to avoid affecting the next use.

If you have any questions, you can send them to my email : tanyatao@qinahaochem.com

whatsapp: 17718245679